Philips FC9160 Bedienungsanleitung Seite 12

English
1
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Customer Care
Centre in your country.
1 The suction power is insufficient.
A The dustbag may be full.
- Empty the reusable dustbag (specific types only) or replace the paper dustbag.
B The filters may be dirty.
- Clean or replace the filters.
C The suction power may be set to a low setting.
- Set the suction power to a higher setting.
D The nozzle, tube or hose may be blocked up.
- To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible)
the other way around. Switch on the vacuum cleaner to force the air through the blocked-up
item in opposite direction (Fig. 37).
 The infrared remote control (specific types only) does not function.
A Perhaps the batteries do not make proper contact or have not been inserted in the proper way.
- Remove the lid of the battery compartment and push the batteries back into place. Make sure
that the - and + poles point in the right direction (Fig. 14).
B The batteries may be empty.
- Replace the batteries.