Raleigh IMPULSE EVO Originalbetriebsanleitung Seite 206

Display message
"Setting cannot be requested from/by
motor."
"Check speed sensor"
"Back pedal sensor: \n"\ /Hardware
defective"
"Waiting for drive"
"No 36 V battery voltage"
"Fault with rotor magnet"
"Fault with rotor sensor"
"Back pedal sensor / range fault"
Start of transfer failed
Init. transfer failed
Data transfer failed
End transfer failed
Fault: Address not within permitted range
Fault: No address received
Fault: Unable to save data
Cause Remedy
Cable connection defective. Contact your cycle dealer to have the cable connection checked and/or repaired.
a) The spoke magnet has a) Check whether the spoke magnet has slipped. It should be as close as possible to the speed sensor on the
slipped.
b) The speed sensor is faulty. b) Contact your cycle dealer to have the speed sensor replaced.
c) Spoke magnet missing. c) Contact your cycle dealer. He will be able to replace the spoke magnet.
d) Assist mode is queried at d) The message should disappear when travelling at over 6 km/h.
standstill.
Coaster sensor defective. Contact your cycle dealer. The motor may have to be replaced.
Motor is not ready yet. The message should disappear after 5 to 6 seconds.
a) No connection to battery. a) Remove battery and reinsert it.
b) Dirty contacts. b) Clean the battery discharge plug and docking station contacts with a soft, dry cloth.
c) The battery is damaged.
d) Battery not charged. d) Charge the battery.
The motor unit is faulty. Contact your cycle dealer. The motor may have to be replaced.
The motor unit is faulty. Contact your cycle dealer. The motor may have to be replaced.
Coaster sensor defective. Contact your cycle dealer. The motor may have to be replaced.
Transfer fault 1. Switch the system off and back on three times
Possibly out-dated software 1. Switch the system off and back
version
chain stay (max. 10 mm). Align the magnet with the marker point on the speed sensor.
c) Damaged batteries must not be charged or used for any other purpose. Contact your cycle dealer.
The battery may have to be replaced.
on 6.3 Overview and basic functions Page
persists, contact your cycle dealer. The system software may need updating.
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
 6.3 Overview and basic functions Page
EN-47. If the fault message
EN-47.
EN-99