Tighten The Drop-Out Screws To A Torque Setting Of 16 - 20 Nm In A Clockwise Direction - Raleigh IMPULSE EVO Originalbetriebsanleitung

6. Pluck the belt so that it vibrates like a guitar string. The app converts
the sound into the natural frequency of the belt.
7. Turn the crank a quarter of a revolution and repeat the measurement.
8. Compare the frequency of the belt with the reference value to see if the
tension needs adjusting.
Specified tension
Short, light rider
values
Hub gear
50 Hz
Adjusting the belt tension
1. Remove the pedelec battery.
2. Undo the bolts from the drop-out by
turning them anticlockwise.
3. Increase or reduce the tension with
the set screw. Make sure the wheel is
refitted straight.
Tall, heavier rider
60 Hz
For 2. Loosen screws
Set screw
For 3. Set screw
IMPORTANT
KORREKTE AUSRICHTUNG CDC-ZAHNKRÄNZE SIND
Correct Sprockets are not
NICHT KORREKT AUSGERICHTET
alignment aligned correctly
When adjusting the tension, the correct alignment of the belt must be
maintained. Otherwise it can cause noise, premature wear of the belt
or sprocket, and the belt to come off the drive.
Fig.: Gates Corporation: Gates Carbon Drive User Manual. 2014, Page 13.
URL: http://www.gatescarbondrive.com/Tech/Resources (as of 07/01/2016)
4. Tighten the drop-out screws to a
torque setting of 16 - 20 Nm in a
clockwise direction  12. Torque
settings Page EN-103.
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
CDX-ZAHNKRÄNZE SIND
Sprockets are not
NICHT KORREKT USGERICHTET
aligned correctly
For 4. Tighten screws
EN-25