Raleigh IMPULSE EVO Originalbetriebsanleitung Seite 137

3.10.1.5 Shift unit: Change shift cable
Path: Settings | Device settings | Shift unit | Change shift cable
This function must only be used when the gear cable needs to be replaced.
In this case the shifter actuator moves to its gear cable replacement
position. Please read the instructions on the display.
IMPORTANT
Make sure the gear cable head is
fully pressed into the white plastic
slide groove provided.
1. Navigate to the "Gear cable replacement" menu option as described in
 6.4.1 Configuring settings in the main menu Page
2. The following text is shown on the display - "The shift unit is now in
the gear cable replacement position. You can remove the cable and/or
mechanically readjust it. Please press SET to end."
3. Briefly pressing the button returns you to sub-level 3.
EN-30 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
3.10.1.6
Path: Settings | Device settings | Shift unit | Slope sensor
The Slope sensor detects whether the pedelec drives uphill or downhill
and adjusts the circuit. If different components have been installed on
the front and rear wheel, recalibration may be required. To do this, follow
these steps:
1. Navigate to the "Slope sensor" menu as described in
Configuring settings in the main menu Page
Gear cable head 2. The following text is shown on the display: "Please bring bike into
straight position. Start calibration?".
3. Select the No or Yes by using the / buttons. The selection is
highlighted. You return to sub-level 3.
Plastic slides
Gear cable head
EN-54.
Shift unit: Slope sensor
The calibration process takes about one second to complete
with return to the menu. Keep the pedelec in the upright
position for this period.
 6.4.1
EN-54.