Herunterladen Inhalt Inhalt Diese Seite drucken

Tunze 1074/2 Gebrauchsanleitung Seite 29

Inhaltsverzeichnis

Werbung

Installation
The description of the installation is based on the
assumption that the knowledge of a plumber is
given in handling the materials (adhesives) used
as well as in employing the tools used. Prior to
the installation, these instructions have to be read
through completely ! The manufacturing company
shall not assume any liability for damage caused by
inexpert or wrong installation.
Wall Overflow 1076/2 requires a lateral glass
borehole in the aquarium of diam. 43 mm to 45 mm
(1.69 in. to 1.77 in.)(1).
Place the outlet with thread in the borehole (2).
Caution ! The black gasket is fitted on the inside of
the aquarium (3) whereas the white plastic ring is
placed on the outside side (4).
The Teflon® tape wound on the thread already must
not be damaged, otherwise attach new Teflon®
tape for sealing.
Screw the elbow onto the threaded connection that
is fitted through the borehole (5).
If the Outlet Hose 1075/2 is used for the wall
overflow, the overflow outlet (6) should be
immobilised by means of PVC adhesive (such as
Tangit, article No. 104.71) in the outlet angle (7).
Montage
Ce montage demande les compétences d'un
installateur professionnel en ce qui concerne
l'usage des colles ou l'utilisation d'outillages
adaptés. Avant le début des travaux, cette notice
doit être entièrement lue ! Nous rejetons toute
responsabilité concernant des dommages dus à
une installation incorrecte ou inappropriée !
Wall Overflow 1076/2 nécessite un perçage latéral
ou arrière ø43-45mm dans l'aquarium (1).
Insérez le déversoir et son filetage dans le perçage
de la cuve (2). Attention ! Le joint d'étanchéité noir se
place toujours sur la face interne de l'aquarium (3),
le joint plastique blanc sur la face externe (4).
La bande téflon posée sur le filetage ne doit pas être
endommagée au quel cas il faudrait la renouveler.
Vissez le coude fileté sur le filetage du déversoir (5).
Si Wall Overflow est utilisé avec le tuyau d'évacuation
1075/2, il sera nécessaire au préalable de coller le
raccord PVC (6) à l'aide de colle PVC (par exemple
Tangit 104.71) dans le coude (7).
29

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1076/21077

Inhaltsverzeichnis