Washing Dishes - Bosch SRI3012 Gebrauchsanweisung

Washing dishes

Programme selection
The most appropriate programme can be
identified by comparing the type of
crockery, cutlery, etc., as well as the
amount and condition of food remains,
with the details contained in the
programme overview.
The corresponding programme sequence,
duration and consumption details are
shown in the bottom half of the overview.
For example:
Use the "Normal"
and utensils which have plenty of food
remains stuck on hard.
Reduce costs!
If only a small number of
dishes have been loaded into
the dishwasher, selecting a
programme that operates at
the next lowest temperature
will usually suffice.
Programme data
The stated programme data are based on
standard operating conditions. The values
can vary considerably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g.
temperature, water volume, ...).
Energy and water consumption is reduced
by up to 1/4 when dishes are washed in
the upper basket only.
Water consumption values are based on a
water hardness setting of 2.
programme for dishes
Switching the dishwasher ON
Set the programme selector
required programme (turn clockwise
only)
Press the main switch
The indicator light
The programme starts.
Switching the dishwasher OFF
Several minutes after the programme has
ended:
Set the main switch
The indicator light
Turn the water tap off. (Does not apply
when Aqua–Stop unit has been fitted)
It is not necessary to reset the
programme selector.
Remove dishes, etc. when they have
cooled down.
Interrupting the programme
Set the main switch
Indicator lights extinguish.
If the hot water was switched ON or the
appliance has already heated up and
then the appliance door opened, leave
the door ajar for several minutes and
then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to resume the programme, set
the main switch to ON again.
Altering the programme
If you want to alter the previously selected
programme, press the main switch
and turn the programme selector
the new programme. Press the main
switch again.
Check whether the detergent compartment
is still closed. If necessary, fill up with
detergent again.
Programme sequence indicator
While the dishes are being washed, the
programme selector rotates in a clockwise
direction and indicates how far the
programme has progressed.
en
to the
1
.
5
illuminates.
7
to OFF.
5
extinguishes.
7
to OFF.
5
5
to
1
35