General Operation - AEG BSS 4803 BT Bedienungsanleitung

First Use of the Device/Introduction
NOTE:
• The device is operated primarily with the remote con-
trol. Thus the descriptions refer to the buttons on the
remote control. Some buttons are also on the device.
Buttons with the same name have the same function.
• The buttons on the device are touch buttons. Touch the
keys lightly with a finger to perform the function.
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Insert/Replace Battery in Remote Control
• Open the battery compartment on the underside of the
remote.
• Insert AAA/R03 1.5 V type batteries. Pay attention to the
correct polarity (see bottom of battery compartment)!
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• Do not expose the batteries to intense heat, such as
sunlight, fire or similar. Danger of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
• Different battery types or new and used batteries may
not be used together.
• Batteries must not be disposed of in the garbage.
Please bring used batteries to competent collection
centers or back to the dealer.

General Operation

Switch device on/off
• With the button (11), you can switch the unit between
standby and operating mode. In standby, the pilot lamp
(7 on the device) lights red.
• To disconnect the unit completely from the mains, pull
the mains plug from the socket.
NOTE:
Keep the button (2) on the unit pressed to toggle the
unit between standby and operating mode.
Volume
By pressing the VOL+/VOL- buttons (6/3) you can adjust the
desired volume.
Infrared Remote Control
For wireless control within a distance of 5 m. If the distance
decreases you should change the batteries. For proper
operation mind a clear view between the remote control and
the sensor on the device.
Sound Settings
If necessary, change the EQ setting in your playback unit to
create the best sound.
MUTE (9)
For immediate muting of the volume. Press MUTE again to
cancel the function.
NOTE:
The activated setting is shown on the display by the "
symbol.
Playing back music files
You have three options to play back your own music files with
the unit: hardwired, wireless via Bluetooth, or via the USB
port.
By cable
1. Connect the 3.5 mm stereo RCA cable to an external
audio source. If required, use a suitable adapter (not
included).
2. Insert the other end of the cable into the AUX-IN jack
(Back Side) on the unit.
3. Repeatedly press the MODE button (2/1) until "AUX" is
shown on the display.
4. Start the playback of your audio source. Listen to the
sound playback via the speaker. You can adjust the
volume using the VOL+/VOL- buttons (6/3).
5. For the further procedure, please refer to the user manual
of the external audio source.
English
31
"