Maintenance And Cleaning; General Information - HomeMatic Wettersensor – pro HmIP-SWO-PR Bedienungsanleitung

The system LED stops flashing and the device performs
a restart. After the restart, you can again integrate your
device into your Homematic IP system.
10

Maintenance and cleaning

10.1

General information

This device does not require you to carry out any
maintenance other than replacing the battery and
cleaning the device when necessary. Enlist the
help of an expert to carry out any maintenance or
repairs.
The weather sensor will need to be cleaned from time to
time to remove the dirt that will accumulate on it. When
you do this, you should also check that the wind sensor
can move easily and that the sensors are properly seated
on their supports.
Clean the product using a soft, lint-free cloth that is clean
and dry. You may dampen the cloth a little with lukewarm
water in order to remove more stubborn marks. Make
sure that no moisture will ingress into the housing. Do
not use any detergents containing solvents, as they could
corrode the plastic housing and label.
Check that your product is safe from a technical
point of view (that the housing is not damaged, for
Maintenance and cleaning
65