Restoring The Factory Settings - HomeMatic Wettersensor – pro HmIP-SWO-PR Bedienungsanleitung

Restoring the factory settings

1x orange and
1 x green lighting
9 Restoring the factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the weather sensor,
please proceed as follows:
Loosen the cover of the main sensor (G) by turn-
•
ing the cylinder clockwise and pulling it down-
wards.
• Remove a battery.
• Insert the battery and press and hold down the
system button (K) at the same time using a point-
ed object, e.g. a pen (see fig. 4) until the system
LED (J) slowly starts flashing orange.
• Press and hold down the system button again un-
til the system LED starts quickly flashing orange.
• Release the system button to finish restoring of
the factory settings.
• Slide the cover from the bottom onto the main
sensor and latch it into place by turning it an-
ti-clockwise.
64
Test display/
system start
Once the test
display has
stopped, you
can continue.