Bosch ART ACCUTRIM 2300 Originalbetriebsanleitung Seite 16

OBJ_BUCH-2337-001.book Page 16 Tuesday, November 4, 2014 3:26 PM
16 | English
Battery Charging
 Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Charging Procedure
The charging procedure starts as soon as the mains plug of
the battery charger is plugged into the socket outlet and the
battery is inserted into the charging compartment.
The battery charge indicator is not a charge-control indicator.
The lit indicator signalises the flow of charging current.
The charging procedure is not ended automatically. There-
fore, disconnect the battery charger from the mains supply af-
ter the battery has been charged and remove the battery. A
temperature increase of the battery indicates that the battery
is fully charged.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see section "Technical Data".
Rapid-charging Procedure
The rapid-charging procedure is indicat-
ed by flashing of the charge control LED.
Troubleshooting
d.c.
Problem Possible Cause
Blade guard can not be Incorrect assembly
mounted over cutting disc
Trimmer fails to operate Battery discharged
Battery too hot/cold
Trimmer runs intermittent- Internal wiring of machine damaged
ly
On/Off switch defective
Excessive vibrations/noise Machine defective
Blade broken
Cutting time per battery Battery has not been used for long pe-
charge too low riod or only for short terms
Grass too high
Battery dead or defective
Blade will not move Battery discharged
Machine defective
F 016 L81 209 | (4.11.14)
The battery is fully charged as soon as the LED switches from
flashing to being lit continuously. Afterwards the battery can
be removed for immediate use.
It is recommended not to remove the battery until the battery
is fully charged.
Trickle-charging Procedure
The trickle-charging procedure is indicat-
ed by continuous lighting of the LED.
With the battery fully charged, the charg-
er immediately switches to trickle-charge
mode. This equalizes the natural running-down of the battery
again.
Charging Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charg-
er.
A battery that is new or that has not been used for a longer pe-
riod will not achieve its full capacity until after approx. 5
charging and discharging cycles. Leave such a battery in the
battery charger until it has warmed up considerably.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.
Corrective Action
Remove cutting disc and mount blade guard again; also
see "Mounting"
Recharge battery; also see "Battery Charging"
Allow to cool/warm
Contact Service Agent
Contact Service Agent
Contact Service Agent
Replace the blade
Fully charge battery; also see "Battery Charging"
Cut in stages
Replace the battery
Recharge battery; also see "Battery Charging"
Contact Service Agent
Bosch Power Tools