Noxon dRadio 110 Bedienungsanleitung Seite 22

It is possible that the device is automatically reset to its factory settings on a firmware
update. This means your individual settings will get lost. We apologize for this, but this is
partly necessary to really update the full functionality of the device.
Flash process
1. Turn off the device with the power switch on the rear panel (do not switch the device
into standby).
2. Insert the prepared USB stick into the USB port on the rear panel.
3. Press the SCAN button, keep holding it down, and then turn on the
device.
4. A progress bar will display the flash process now.
This process should not be interrupted under any circumstances. Do not power
off the device or unplug the USB stick during the update process since this would
irreversible destroy the device.
5. If no progress bar is shown, the USB stick is not detected by the dRadio 100. Please
check if the USB stick is inserted correctly. If this is the case, please review and re-
peat the steps specified above.
6. After successfully updating the firmware the message "Done" will be displayed and
shortly thereafter the display turns black.
7. Turn off the device with the power switch on the rear panel (do not switch the device
into standby).
8. Now you can remove the USB stick and switch your dRadio 100 back on again.
Enjoy the dRadio 110!
Your Terratec Team.
22