Specifications - Victron energy MPPT 150/35 Anleitung

5. Specifications

SmartSolar charge controller
Battery voltage
Maximum battery current
Nominal PV power, 12V 1a,b)
Nominal PV power, 24V 1a,b)
Nominal PV power, 48V 1a,b)
Max. PV short circuit current 2)
Maximum PV open circuit voltage
Peak efficiency
Self consumption
Charge voltage 'absorption'
Charge voltage 'equalization' 3)
Charge voltage 'float'
Charge algorithm
Temperature compensation
Protection
Operating temperature
Humidity
Maximum altitude
Environmental condition
Pollution degree
Data communication port and
remote on/off
Colour
Power terminals
Protection category
Weight
Dimensions (h x w x d)
Safety
1a) If more PV power is connected, the controller will limit input power.
The
1b) PV voltage must exceed Vbat + 5V for the controller to start.
the
Thereafter minimum PV voltage is Vbat + 1V.
2) A higher sort circuit current may damage the controller in case of reverse
polarity connection of the PV array.
3
) Default setting: OFF
12
MPPT 150/35
12/24/48V Auto Select (36V: manual)
500W (MPPT range 15V to 130V)
1000W (MPPT range 30V to 130V)
2000W (MPPT range 60V to 130V)
Default setting: 14,4V / 28,8V / 57,6V
Default setting: 16,2V / 32,4V / 64,8V
Default setting: 13,8V / 27,6V / 55,2V
Multi-stage adaptive (eight preprogrammed algorithms)
or user defined algorithm
-16mV / -32mV / -68mV / °C
Battery reverse polarity (fuse, not user accessible)
Output short circuit / Over temperature
-30 to +60°C (full rated output up to 40°C)
95%, non-condensing
5000m (full rated output up to 2000m)
Indoor type 1, unconditioned
VE.Direct (see the data communication white paper on
ENCLOSURE
Blue (RAL 5012)
13mm² / AWG6
IP43 (electronic components), IP 22 (connection area)
130 x 186 x 70 mm
STANDARDS
EN/IEC 62109-1, UL 1741, CSA C22.2
35A
40A
150V
98%
10mA
(adjustable)
(adjustable)
(adjustable)
PD3
our website)
1,25kg