Environment Protection; Control Panel; Switching On; Switching Off - AEG SANTO K 9 12 05-6i Gebrauchsanweisung

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable regulations to obtain from your
local authorities. Avoid damaging the cooling unit, especially at the rear near the heat
exchanger. The materials used on this appliance marked by the symbol

CONTROL PANEL

1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)

4. Temperature indicator

5. Temperature regulator (coldest)
6. COOLMATIC indicator
7. COOLMATIC switch

Switching on

1. Plug the mains plug into the mains socket.
2. Press ON/OFF switch.
3. The pilot light will light up.

Switching off

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the appliance is turned off. The temperature indicator switches off. The Pilot
light switches off.
Temperature indicator
The temperature indicator shows the fridge temperature currently set .

Temperature regulation

The temperature can be adjusted between +2°C and +8°C.
By pressing the Temperature regulators, the current temperature setting flashes on the
Temperature indicator. It is possible to modify the setting temperature only with flashed
indicator.
• To set a warmer temperature, press Temperature regulator +.
• To set a colder temperature, press Temperature regulator -.
1 2 3 4 5 6 7
5
Control panel
are recyclable.