Wall Unit Mounting - AEG DM 8700 Benutzerinformation

Wall unit mounting - Fig. 7
First decide which functioning mode is better for you.
If you decide to use the hood in extraction mode we suggest you position
the upper section of the chimney so that the oulet slots are not visible
once installation is completed, however if is decided to use the hood in
rrecirculation mode BE SURE that the side with slots is up (see also A-B-
C sequence on on Fig. 7).
Assembling the chimney flue support/bracket (3 parts):
The three parts should be fixed with 4 screws, the support extension
is adjustable and should correspond to the internal width of the
telescopic chimney flue.
Assembling the deflector (3 parts – only for filter version):
The three parts should be fixed with 2 screws, the deflector
extension is adjustable and should correspond to the width of the
chimney flue support, to which it is then fixed.
A
C - OK!
Fig. 7
78
B
=
X
180°
G
F
=
X
F
H
X
=
=
G