Electrical Connection; Chimney Assembly - AEG DD8694-M Gebrauchsanleitung

8
RECIRCULATION VERSION AIREOUTLET
• Insert the connection extension pieces laterally
14.1 in connection 15.
• Insert the Connector 15 into the Support bracket
7.3 and fix it with a screw.
• Make sure that the outlet of the extension pieces
14.1 is horizontally and vertically aligned with
the chimney outlets.
• Connect the air outlet connection 15 to the hood
body outlet using either a flexible or rigid pipe
ø 150 mm, the choice of which is left to the
installer.
• Ensure that the activated charcoal filters have
been inserted.

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-
pole switch having a contact gap of at least 3
mm.
• Remove the grease filters (see paragraph Main-
tenance) being sure that the connector of the
feeding cable is correctly inserted in the socket
placed on the side of the fan.

CHIMNEy ASSEMbLy

Upper exhaust Chimney
• Slightly widen the two sides of the upper flue
and hook them behind the brackets 7.2.1, making
sure that they are well seated.
• Secure the sides to the brackets by using the 4
screws 12c (2,9 x 9,5) supplied.
• Make sure that the outlet of the extensions pieces
is aligned with the chimney outlets.
Lower exhaust Chimney
• Slightly widen the two sides of the chimney and
hook them between the upper chimney and the
wall, making sure that they are well seated.
• Fix the lower part laterally to the hood body
using the 2 screws 12c (2,9 x 9,5) supplied.
����
���
��
�����
�����
���
�
���
�
EN
���
���
���