Renlig FWM7 Gebrauchsanleitung Seite 22

ENGLISH
Problem
The appliance does not
drain the water.
The spin phase does not
operate or the washing
cycle lasts longer than
usually.
There is water on the
floor.
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an option. • Make sure that you press only the wanted button(s).
After the check, activate the appliance. The
programme continues from the point of
interruption.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without
drain phase.
• Set the drain programme if you set an option which ends
with water in the drum.
• If above mentioned solutions do not help, contact the Au-
thorised Service Centre (as the filter of the drain pump may
be clogged).
• Set the spin programme.
• Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
• If above mentioned solutions do not help, contact the Au-
thorised Service Centre (as the filter of the drain pump may
be clogged).
• Make sure that the couplings of the water hoses are tight
and there is not water leakages.
• Make sure that the inlet hose and/or the drain hose have
no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure the levelling of the appliance is correct. Refer to
'Installation Instruction'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation Instruction'.
• Add more laundry in the drum. The load may be too small.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Possible solution
If the problem occurs again, contact the
Authorised Service Centre.
22