Safety - Avdel T10 Betriebsanleitung

S a f e t y
This instruction manual must be read with particular attention to the following safety rules, by any person
installing, operating, or servicing this tool.
1 Do not use outside the design intent.
2 Do not use equipment with this tool/machine other than that recommended by Avdel UK Limited.
3 Any modification undertaken by the customer to the tool/machine shall be the customer's entire responsibility.
4 Always disconnect the tool from the hydrapac before attempting to adjust, remove or fit the nose assembly.
5 Do not operate a tool/machine that is directed towards any person(s).
6 Always adopt a firm footing or a stable position before operating the tool/machine.
7 It is recommended that ear and eye protection be worn by the operator and those in the vicinity.
8 Do not fit flexible hoses rated at less than 10,000 psi (69 mPa) working pressure.
9 The operating pressure shall not exceed 8,000 psi (55.2 mPa).
10 Care shall be taken to ensure that spent pintails are not allowed to create a hazard.
11 The flexible pintail deflector T108 must always be attached to the tool and in good condition.
12 Take care to avoid entanglement of loose clothes, ties, long hair, cleaning rags etc. in the moving parts of the tool.
13 The tool should be kept clean and dry for the best possible grip.
14 When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent start up.
15 The machine must be maintained in a safe working condition at all times and examined at regular intervals for damage and function by
trained competent personnel. Any dismantling procedure shall be undertaken only by personnel trained in Avdel
dismantle the machine without prior reference to the maintenance instructions. Contact Avdel
16 The machine shall at all times be operated in accordance with relevant Health & Safety legislation. In the UK the "Health & Safety at Work
etc Act 1974" applies. Any question regarding the correct operation of the machine must be directed to Avdel
AVDEL RECOMMENDS THAT ONLY HYDRAPAC UNITS BE USED TO DRIVE INSTALLATION TOOLS, AS OTHER MAKES OF
HYDRAULIC POWER UNITS MAY NOT OPERATE AT THE SAFE DESIGNED WORKING PRESSURES.
ENSURE THAT THERE IS ADEQUATE CLEARANCE FOR THE TOOL OPERATOR'S HANDS BEFORE PROCEEDING.
DO NOT ABUSE THE TOOL BY DROPPING OR USING IT AS A HAMMER.
KEEP DIRT AND FOREIGN MATTER OUT OF THE HYDRAULIC SYSTEMS OF THE TOOLS AS THIS WILL CAUSE THE TOOL
AND HYDRAPAC TO MALFUNCTION
4
CAUTIONS
®
procedures. Do not
®
with your training requirements.
® .