Audiosonic CD 570 Bedienungsanleitung Seite 9

Fingerprints:
If you are unable to clean the lens with the camera lens brush, use a dry cotton swab
to clean the surface, from the center to the outside.
TROUBLESHOOTING
TROUBLESHOOTING
If a problem occurs, check the points below before taking the apparatus in for repair.
Do not open the apparatus to prevent all risk of electrocution.
If you are unable to solve a problem using the indications provided below, contact
your dealer or after-sales service center.
WARNINg: Under no circumstances should you attempt to repair the apparatus
yourself; doing so will void the guarantee.
NO SOUND / ELECTRIC POWER
The volume is not properly set.
The electrical power cord is not plugged
in correctly.
The batteries are dead/not inserted
correctly.
THE DISPLAY UNIT DOES NOT FUNCTION CORRECTLY / THE BUTTONS DO NOT FUNCTION
Electrostatic discharge.
NO INFORMATION DISPLAYED ABOUT THE DISC
No CD in the player.
The CD is scratched or very dirty.
Adjust the volume.
Check the power cord connections.
Check the installation and charge of the
batteries.
Turn the unit off and disconnect it. Plug it back
in a few seconds later.
Insert a CD, CD-R or CD-RW in the player.
Replace/clean CD. See Maintenance.
The laser lens is covered with
condensation.
The CD-R is blank or the disc is not
finalized.
THE CD IS NOT READ
The CD is scratched or very dirty.
The laser lens is covered with
condensation.
THE CD SKIP TRACKS
The CD is scratched or dirty.
A program sequence us activated.
IMPORTANT
Note: Although this CD player can read CD-R, CD-RW and MP3 discs - in addition to
normal CD's - the playability of CD-R, CD-RW and MP3 discs may be affected by the
type of software that was used to create the discs, as well as the quality and condition
of the blank media you are using. 100% playability cannot be guaranteed. This is not
an indication of a problem with the player.
Important
• The USB port of this product is fully compatible with the USB 1.1 and 2.0 standard.
• If MP3 players connected to this port are not written in compliance with the
official USB 1.1 or 2.0 standard it may occur that those MP3 players do not work
on this port.
• This is not a defective of this product.
• The MP3 player does not comply with the official USB 1.1 or 2.0 standard.
Instruction Manual
Wait until condensation disappears from
the lens.
Use a finalized CD-R.
Replace/clean CD. See Maintenance.
Wait until condensation disappears from
the lens.
Replace/clean CD. See Maintenance.
Exit the programming mode(s).
EN
9