Further Information; Connecting Usb 2.0 Mass Storage Devices; Pin Assignment Of The Rs232 Socket - G&D DL-MUX2-DP1.2-MC2 Bedienungsanleitung

Further information

Connecting USB 2.0 mass storage devices

Any USB devices can be connected to the USB 2.0 interfaces on the front panel of
the KVM switch.
If the active channel is switched by the user, the USB device is no longer provided to
the so far active computer. In case the computer writes data on the mass storage
device at that time, this process is aborted.
Before switching the channel, use the Safely remove hardware function of the applied
operating system of the computer to avoid data loss.

Pin assignment of the RS232 socket

The devices of the DL-MUX series provide an RS232 socket.
The following figures shows the pin assignments of the RS232 socket:
The table shows how the different conduits of the data connection are assigned to
the according pins:
Pin no. Conduit
1
not occupied
2 RxD (Receive Data)
3 TxD (Transmit Data)
4 not occupied
5 GND (Ground)
6 not occupied
7 RTS (Request to Send)
8 CTS (Clear to Send)
9 +5V DC, max. 100 mA (necessarily see advices below!)
5 4 3 2 1
9 8 7 6
Further information
G&D DL-MUX2-DP1.2-MC2 · 31