Switching Commands; Messages; Switching Via Web Application; Switching Via Snmp - G&D DL-MUX2-DP1.2-MC2 Bedienungsanleitung

Switching between the computers

Switching commands

The following commands are provided for switching the channel:
Command Channel
1! 1
2! 2
<! switch to previous channel
>! switch to next channel
NOTE: The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.

Messages

The KVM switch confirms the successful execution of a command and otherwise
sends a meassage.
Message
In [x] All
E01
E06
E10
E13

Switching via web application

A computer, which is connected to the KVM switch, can be accessed via
Config Panel web application.
The Advanced functions for KVM switches paragraph of the separate manual for the web
application provides detailed information regarding this function.

Switching via SNMP

How to switch the signal transmission via SNMP:
 Use the SNMP management station to set the Managed Object
number of the channel to be switched to.
10 · G&D DL-MUX2-DP1.2-MC2
Meaning
switching to channel
invalid channel number (out of range)
channel switching failed
invalid command
invalid value (out of range)
[x] successful
selectedChannel to the