AEG Electrolux SCS81800F0 Benutzerinformation Seite 79

Problem
The buzzer sounds. The
Alarm light flashing.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC
or COOLMATIC button, or
after changing the tem-
perature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the ap-
pliance is too low/high.
The temperature in the re-
frigerator is too high.
Possible cause
The temperature in the freezer
is too high.
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
FROSTMATIC or COOLMATIC
functions switched on.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
What to do if...
Solution
Refer to "High Temperature
Alarm".
Set a higher temperature.
Do not keep the door open lon-
ger than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set
the temperature until the func-
tion has reset automatically. Re-
fer to "FROSTMATIC or COOLMAT-
IC function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
79