Front Panel - Velleman NVR4 Kurzanleitung

• local and remote control completely independent
HDMI video output resolution up to 1080p
•
automatic integrated Dynamic Domain Name Service (DDNS): free service
•
USB mouse: incl.
•
IR remote control: incl.
•
Optional hardware
• hard disk: HD500GB/S, HD1TB/S, HD2TB/S
monitor: MONSCA9
•
HDMI cable: PAC400Tx series and PAC400Gx series
•
compatible IP cameras: CAMIP16, CAMIP17, CAMIP18, CAMIP19
•
router: EM4544, EM4543, EM4571, PCRT1
•
5. Overview

Front panel

alarm
wan
lan
SATA
HDD1 to HDD5
USB port
mouse port
Back panel
1 2 3
1
AUDIO OUT
HDMI video output
2
port
3 External I/O
4 eSATA
5 WAN
6 LAN
7 DC 19V IN
V. 01 – 14/04/2014
LED indicator: an alarm event occurs
LED indicator: the NVR is connected to internet
LED indicator: the NVR is connected to the LAN
LED indicator: SATA hard disk is active
LED indicator: up to 5 hard disks are installed in the NVR and connected well
(3 HDD with quick-lock installation)
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the
CD-ROM.
Insert a mouse (included).
4 5 6 7
Connect to an amplifier audio line-in.
Connect to a monitor that supports high-definition video output (HDMI port).
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or
composite connectors.
RS 485 port
This port is used to connect a storage device supporting eSATA interface; for
instance, an external disk array.
Connect to internet via an 8P8C (RJ45) network cable
Connect to local IP cameras via an 8P8C (RJ45) network cable.
Connect to the power supply adapter (incl.).
NVR4
4 ©Velleman nv