Channel - Mono Subwoofer - Hifonics TITAN TX400 Bedienungsanleitung

4-Channel Amplifier Speaker wiring and Connections
2-Channel- Mono/Subwoofer
X-Over-(1/2 & 3/4 Channel Amplifier)
• In Mono/Subwoofer-mode you should choose the LOWPASS-position (LOPASS), so the higher frequencies are cut off. The
cut-off frequency should be between 60Hz - 100Hz.It is controlled by the LOWPASS-regulator. In Lowpass-position (LP/BP)
der Highpass-regulator (HI PASS) is activated as Subsonic-Filter.The Subsonic frequency should be between 15Hz -
40Hz,depending on the size of the installed speaker.
INPUT LEVEL
• Turn the INPUT LEVEL control on the amplifier to 6V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Bass EQ
• Allows you to adjust the bass boost from 0dB up to 18dB
Caution! Please use the Bass - EQ carefully. The additional boost may result in clipping or overload.
Remote-Control only works in Ch 3&4. Settings of Bass EQ of Ch 1&2/3&4 must be similar.
Mode
• Should be set on 0dB-postion.
Connect RCA Cable
from head unit with RCA
inputs (LINE INPUT
1CH/2CH).
HIFONICS HIFONICS
POWER PROTECT
0dB 18dB
HFR-1
Remote Control -
Connection for remote
control.Allows you to
adjust the subwoofer
from your seat
Only works when you
use Ch 3&4
TX440 / TX880
Interconnect cable checklist:
• Connect the LINE INPUT of the amplifier to the head unit line output with good quality RCA
to RCA cables.
• Connect the speakers with the terminal block (SPEAKER OUTPUT/ - LEFT + and - RIGHT
+) of the amplifier.
•The minimum final speaker impedance must not be below 2 Ohm per channel. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal
block.Incorrect phasing of the speakers results in total loss of bass response.
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Caution!
Subwoofer 4 - 8 Ohm
Subwoofer 4 - 8 Ohm
29