Maintenance - Wolf Garten Li-Ion Power PSA 700 Originalbetriebsanleitung

Working method
1
Caution! Risk of rebound or recoil
A rebound or recoil may lead to fatal cut in-
juries.
In the event of a rebound or recoil (kick-
back), the saw is turned suddenly and un-
controllably towards the user.
z Avoid touching the tip of the sawing bar
on any object.
z Exert uniform pressure on the device,
but not excessive force.

Maintenance

General
1
Caution! Sharp saw chain
Tool is still running!
z Always remove battery before perfor-
ming any work on the trimmer!
z Wear safety gloves when doing any work
3
on the saw chain!
Have the device checked once a year by
a specialist workshop.
Cleaning
z Clean the device, particularly the ventilation
slots, and with a dry cloth after every use or
with a brush if it is excessively dirty.
z Never spray off the device with water.
Oil guide groove of the sawing bar
1
Caution!
In order to ensure working safely with the
device and adequate oil lubrication of the
saw chain, the guide groove of the sawing
bar must be cleaned if it is very dirty.
1. Dismantle the chain cover, the saw chain and
the sawing bar (see section "Fastening the
saw chain", page 19).
2. Clean the oil guide groove using a suitable tool
(e.g., wire brush).
G
M N
Cutting a tree
3
Remove the branches of the tree trunk
from the bottom to the top.
1. Cut the branch 10-15 cm from the start of the
branch from below upwards up to 1/3 of the
branch diameter
2. Saw off the branch somewhat more from the
top to the bottom
3. Make a cut close to the trunk
3. Mount the saw chain, the sawing bar and the
chain cover (see section "Fastening the saw
3
chain", page 19).
Sawing bar wear
The sawing bar of the device becomes worn
out over time.
z After cleaning it, turn the sawing bar
around by 180°. This balances the wear
and tear and enhances the service life of
the sawing bar.
Storage
1
Caution! Sharp saw chain
Always pull over the protective cover when
storing the device.
z Store the device in a dry place, out of the reach
of children.
z Take care to ensure that no chain lubrication
oil can be discharged while it is stored.
z Keep the device as horizontal as possible with
the oil tank sealing cap facing upwards.
z Remove the chain lubricating oil from the de-
vice for longer storage periods (4 weeks or
more) in order to prevent resin formation in the
lubricating oil pump.
.
.
.
21