Assembly; Operation - Wolf Garten Li-Ion Power PSA 700 Originalbetriebsanleitung

z WOLF-Garten wishes to
encourage users to act in an
environmentally friendly
manner. It therefore
guarantees to take back and
recycle old batteries that are
returned to WOLF-Garten
dealers.

Assembly

General
1
Caution! Sharp saw chain
Tool is still running!
z Always remove battery before perfor-
ming any work on the trimmer!
z Wear safety gloves when doing any work
on the saw chain!
Fastening the saw chain
1. Loosen the nut by hand and remove the chain
A
cover .
2. Place the saw chain around the sawing
B
bar .
1
Take care to ensure that the chain is
moving in the right direction
3. Place the sawing bar along with the saw chain
C
on the device

Operation

Times of operation
z Please consult regional/local regulations.
z Inquire about the operating times at your local
regulatory agency.
G
.
.
Disposal
z Electric tools must not be
disposed with household
waste. Bring the device,
accessories and packaging to
a recycling centre for proper
recycling and disposal.
1
Take care to ensure that the chain ten-
sioning pins
bar.
1
Ensure that the saw chain fits around the
sprocket .
4. Place the chain cover
the device using the nut.
Fastening the saw chain
1
The saw chain should not hang loose,
but it should be possible to pull it a few
millimetres away from the sawing
E
bar .
A
1. Turn the nut
the sawing bar can be moved by hand.
2. Tighten the chain tensioning screw using a
F
screwdriver .
3. Turn the saw chain by hand in order to check
that it runs smoothly and properly.
4. Tighten the nut
Charging
G H
1
Attention! Only use battery charger in
dry places.
Before first use, the battery needs to be charged
for about 2 hours.
Use only the original WOLF-Garten charger
(part no. 41A30--E650)!
1. Remove the battery from the device
2. Insert the battery into the charger
3. Connect the charger to the mains voltage
(LED lights up green).
engage in the sawing
D
and fasten it onto
and loosen it enough so that
A
by hand.
J
H
G
.
.
H
19