Chain Lubrication; Adjusting The Working Height - Wolf Garten Li-Ion Power PSA 700 Originalbetriebsanleitung

3
Notes on charger
z LED
lights up red: Battery is charging
z LED
lights up green: Charging com-
pleted
z LED
blinks red: Fault (e.g., battery is
too hot)
1
Self-discharge of batteries! Remove the
battery from the charger once it is fully
charged.
3
General instructions:
regarding the battery In order to maintain
the long service life of the battery, always
follow the instructions below:
z The lawn trimmer are automatically swit-
ched off when the battery voltage is low.
The battery must then be recharged be-
fore the shears can be used again.
z Always recharge the lithium-ion battery
prior to any prolonged period of non-use,
i.e. before storing the shears away in au-
tumn.
z The charging time is 2 hours for a battery that
is completely empty.
z The lithium-ion rechargeable battery can
be charged at any charge level and char-
ging can be interrupted at any time without
damaging the battery (no memory effect)

Chain lubrication

1
Caution! The device should be operated
only with adequate chain lubrication oil.
Check the oil level with the help of the oil
3
level indicator
Tank capacity 60 ml, is sufficient for ap-
prox. 25 min. of operating time.
Filling up chain lubrication oil
1
Avoid spilling the oil.
Wipe off any oil that may have got spilt.
1. Unscrew the oil tank cover and remove it
2. Fill in the chain lubricating oil carefully until it
reaches the upper marking on the oil level in-
dicator.
3. Tighten the oil tank cover by hand.
20
H
:
K
.
1
Caution!
Take care to ensure that no dirt or contami-
3
nation gets into the oil tank.
Recommendation:
In order to prevent environmental damage,
we recommend the use of bio chain lubricat-
ing oil based on vegetable oils.

Adjusting the working height

1. Loosen the threaded sleeves
2. Pull the telescope handle apart until the ideal
grip height is reached
3. Tighten the threaded sleeves
Working with the high branch remover
1
The high branch remover is meant to
saw off branches and twigs. It should not
be used to fell trees.
1
Prior to each use:
z Check the saw chain and sawing bar for
any signs of damage
z Check the chain tension
z Check the chain lubrication
1
During operation
z Take care to ensure a stable position
and posture, particularly when working
overhead (above head height).
z Hold the saw chain away from the body.
z Hold the device tightly in both hands.
z Never stand directly under the branch to
be cut off.
z Never stand on a ladder or an unstable
surface or ground.
1
Caution! Risk of injury
z Do not saw wood that is under tension.
z Do not saw any shrubs or bushes.
Switching the motor on
1. Press the unlock button
pressed.
2. Press the On / Off button
.
3. Release the unlock button
Switching the motor off
z Release the ON/OFF button
K
.
.
.
L
and keep it
.
.
L
.
G