Care And Storage; In The Event Of Problems; Technical Data - Beurer MG 90 Gebrauchsanweisung

The heat function can be switched on during any massage program, by pressing the "Heat" button.
Replace the massage attachments by rotating the attachment on the product in an anti-clockwise direction and
replacing. Fix the newly positioned massage attachment in place by rotating it in a clockwise direction.
Guide the device with both hands to the area of the body to be massaged. You can stand, sit or lie down and
can massage yourself or another person. The massage intensity can be altered by pressing more or less firmly
with the massage device. Do not massage a certain site of the body for longer than 3 minutes and then change
to other area of the body.
After using for a maximum of 15 minutes, unplug the device and let it cool down. Keep the device dry.
Note
• Do not use the massage device just before going to bed. The massage can also have a stimulating effect
and may cause difficulties in getting off to sleep.
WARNING
• The massage must be pleasant and relaxing at all times. Stop the massage or change the position of the
massage device if you find it is painful or unpleasant.
• Do not jam or force any part of your body, in particular your fingers, into the area of the massage head.

7. care and storage

cleaning
To clean the unplugged and cooled device, wipe with a slightly damp microfibre cloth. Then you can clean it with
a cloth which is no more than lightly moistened. You can also use a mild detergent.
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device or
accessories.
• Do not use the device again until it is completely dry.
storage
Keep the massage device in a cool and dry place where it is out of the reach of children. We recommend storing
the device in its original packaging.

8. In the event of problems?

Problem
Massage head does
not move.

9. technical data

Dimensions (W/H/D)
Weight
Rated output
Rated voltage
cause
Appliance not connected
to the power supply.
Device is not does not move. Switch on the appliance.
Overheating protection
tripped.
~ 175/400/95 mm
~ 1250 g
22 W
220-240 V ~ 50 Hz
Remedy
Connect the plug to the mains supply and
switch on the appliance.
Disconnect device from mains power, wait at
least 15 minutes, plug in again and switch on.
10