Labels Supplied With The Accessories Bag - AEG 99553GM Benutzerinformation

30
What to do if...
Problem
The flame is blow out immedi-
ately after ignition
The gas ring burns unevenly
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a
solution to the problem yourself, speak your dealer or the local Service Force Centre.
If you operated the appliance incorrectly, or the installation was not carried out by a regis-
tered engineer, the visit from the customer service technician or dealer may not take place
free of charge, even during the warranty period.

Labels supplied with the accessories bag

Stick the adhesive labels as indicated below:
1
MOD.
PROD.NO.
SER.NO
DATA
MODEL
1 Stick it on Guarantee Card and send this part
2 Stick it on Guarantee Card and keep this part
3 Stick it on instruction booklet
These data are necessary to help you quickly and correctly. These data are available
on the identification plate from the injectors kit.
• Model description .................
• Product number (PNC) .................
• Serial Number (S.N.) .................
Use the original spare parts only. They are available at Service Force Centre and approved
spare parts shops.
• Burner cap and crown are
placed uneven
• Thermocouple is not heated
sufficient
• Burner crown is blocked
with food residues
2
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
MODEL
Possible cause
3
MOD.
PROD.NO.
0049 SER.NO.
Remedy
• Make sure that the burner
cap and crown are in correct
positions.
• After lightning the flame,
keep the knob pushed for
approximately 5 seconds.
• Make sure that the injector
is not blocked and the burn-
er crown is clear of food
particles.
TYPE
230V-50Hz
IP20