Cleaning The Spray Arms; External Cleaning; Troubleshooting - AEG FAVORIT 65050 I Benutzerinformation

30 www.aeg.com

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
The programme
does not start.
A1
A2
Possible cause
The mains plug is not con-
nected in the mains socket.
The appliance door is
open.
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
Make sure that it assembles correct-
ly under the two guides (C).
6.
Assemble the filter (A) and put it in-
to position in filter (B). Turn it clock-
wise until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Connect the mains plug.
Close the appliance door.