Wheel Remote Control; Connecting The Wheel Remote Control; Instance Image Of The Can Bus; Connecting The Cables - Xomax XM-2DTSBN6214 Montageanleitung

Topic:

Wheel remote control

EN
Wheel remote control
Connecting the wheel remote
control
To connect the wheel remote control
please consult the manual of your
vehicle.
i
For connection of the wheel
remote control you will need a CAN
bus adapter appropriate for your
vehicle. This could be provided from
your local specialist supplier.
!
Please let a professional technici-
an install the wheel remote control in
your vehicle. The incorrect installation
may cause serious defects of the unit
and of the vehicle electronics.
The damages caused by an inappro-
priate installation are not covered
by warranty.
XOMAX

Instance image of the CAN bus

Connecting the cables

» "Key 1" (+) with "Can high" (+)
» "Key 2" (+) with "Can low" (+)
» "Ground" (-) with "Ground" (-)
Connection advices
» "Key 1" and Key 2" could be interch-
anged if required.
» Under no circumstances (+) and (-)
may be connected with each other.
» Depending on CAN bus type it is
possible that only one of the (+)-
cables should be connected.
» Function test: Please press one of
the buttons on the remote control – the
assigned sensor key in the adjustment
menu
(wheel control)
46
should light up.
X M - 2 D T S B N 6 2 1 4