Installing Appliance Under Worktop - Siemens KT..L Serie Gebrauchsanleitung

en
Installing appliance
under worktop
After removing the worktop, the appliance
can be installed under a worktop.
Fig. 1
Removing the worktop
S Unscrew screws at the rear
of the worktop.
S Lift worktop slightly and remove.
Appliance ventilation
A ventilation cross section of
minimum 160 cm
installation below a worktop. For this
purpose, a vent measuring about
500 x 60 mm is required, which is
available from DIY shops or specialist
retailers.
S Mark the cut out for the vent on
the worktop centric to the appliance.
S Max. distance to wall 83 mm
S Note width B" of the wall connection
rail!
S Saw out the cutout. Chamfer
the underside by approx. 4 mm.
S Insert and attach the ventilation grille.
Note
The vent is not required when
the distance between the worktop
and appliance is more than 5 cm.
24
2
is necessary for
Prior to installation
Before the appliance is pushed into
a corner, the tabs from the top cover strip
must be bent upwards; the tabs should
previously be lifted with a knife or similar.
Fig. 2/B
Appliance installation under worktop
Insert the appliance into the cavity until
the front edge of the appliance door
is flush with the furniture doors of
the adjacent cupboards.
Align the appliance with the
height adjustable feet until the upper
edge of the appliance is situated on
the worktop.
Adjust the height adjustable feet with
a screwdriver. Fig. 2/A
Fixing appliance to the worktop
Secure the appliance to the worktop with
standard chipboard screws.