Zanussi ZRT 623 W Benutzerinformation Seite 23

1. Remove the plug from
the power socket.
2. Open the door of the
freezer. Loosen the hinge.
6. Unscrew the bottom far
side screw and install on
the opposite side.
10. On the opposite site,
install the hole covers.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
2
1
3
3. Remove the doors by
pulling them slightly and
remove the hinge.
7. Unscrew the top door
holding pin.
11. Tighten the hinge.
Make sure that the doors
are aligned.
4. On the opposite side, re-
move the hole covers.
8. Screw the pin back on
the other side.
12. Remove and install the
1)
handle
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
5. Unscrew both adjustable
feet and the screws of the
bottom door hinge. Remove
the bottom door hinge and
install it on the opposite
side.
2
3
1
9. Fit the doors into the
pins and install the doors.
Install the hinge.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.
23