Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A)
If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhere in
the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be
protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow:
Blue:
Brown:
ELECTRICAL CONNECTION (UK ONLY)
E
Earth
L
Neutral
N
Live
If the plug is a moulded-on type, the fuse cover must be re-fitted when
changing the fuse using a 13 Amp Asta approved fuse to BS 1362.
In the event of losing the fuse cover, the plug must NOT be used
until a replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse cover is
that as marked on the base of the plug.
B)
If your appliance is not fitted with a plug, please follow the
instructions provided below:
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed as
follows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol
green and yellow.
The blue wire must be connected to the terminal marked with the letter N
or coloured black.
The brown wire must be connected to the terminal marked with the letter
L or coloured red.
or coloured green or
Werbung
Inhaltsverzeichnis
