Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING:
Do not turn the volume at max when use this product at public place just like school, office etc.
After long time using the back panel will be hot, do not touch it by hand.
OPERATION OF VHF WIRELESS TRANSMITTER (SPD-series only)
Handheld MIC
Open the battery compartment cover. Insert battery, observing polarity. Re-attach
the battery cover. Turn on the microphone by using the power switch. The battery
LED indicator will light, indicating full battery strength. In the case of a low or dead
battery, the battery LED will extinguish, indicating that the battery should be
replaced with a fresh one. The IR indicator in the amplifier should now be lit. To
preserve battery life, turn the microphone off when not in use. If you are not going
to use the microphone for a long period of time, take out the battery from
microphone to avoid possible battery leakage to damage the microphone.
Note: This unit is supplied with two wireless microphones in two different frequencies which can
be used simultaneously.
NETHERLANDS , GERMANY
This product should only be used in Germany and the Netherlands (and in Spain / Switzerland with restrictions). In
Germany, the end-user must apply for an individual assignment in a locally relevant branch of the Federal Network
Agency (BNetzA).
TROUBLE SHOOTING:
Failure
NO POWER
NO SOUND
ONE SPEAKER WITHOUT SOUND Connection between master & slave unit wrong
MICROPHONE NO SOUND
MICROPHONE HOWL
Possible cause
The power line is cut off or not connected
No power on the electric outlet
Wrong input, check input selector (3)
The connect line was broken
The volume knob at lowest
Signal line was broke
The microphone not complete connected
Adjust the microphone volume
Change microphone
The microphone is too close to the speaker
Master volume adjust too big
Werbung
Inhaltsverzeichnis
