Safety Notes - Blaupunkt velocity va 275 Bedienungs- Und Einbauanleitung

VA 275
Recommendation:
The performance of an amplifi er can only be as good
as its installation. A correct installation increases the
overall performance of your car sound system. The VA
amplifi er should be installed by a trained person. If you
would to install it yourself, please read these installation
instructions very carefully and allow yourself suffi cient
time for the installation.
In conclusion, allow us a few words about the topic of
health protection:
During the playback of music in your vehicle, please
consider that continuous sound-pressure levels above
100 dB can lead to permanent damages to the human ear
and even to loss of hearing. Using today's high-perform-
ance systems and loudspeaker confi gurations allows for
reaching sound-pressure levels above 130 dB.

Safety notes

Please observe the following safety notes
during the installation and connection.
- Disconnect the negative pole of the battery!
Observe the safety notes of the vehicle manufac-
turer.
- When you drill holes, ensure that you do not dam-
age any vehicle components.
- The cross section of the plus and minus cable may
not be less than 6 mm
- Use cable glands for holes with sharp edges.
- An incorrect installation can result in malfunctions
of the electronic vehicle systems or your car sound
system.
Installation and connection instructions
With respect to accident safety, the VA 275 must be
secured in a professional way.
When selecting the installation location, select a dry
location that offers suffi cient air circulation for cooling
the amplifi er.
The VA 275 must not be installed on rear shelves, rear
seats or other locations that are open to the front.
The installation location must be suitable to accept the
accompanying screws and provide a fi rm support.
The amplifi er power cable must be fi tted with a fuse no
more than 30 cm (1,18") from the battery to protect the
vehicle battery in case of a short circuit between power
amplifi er and battery. The fuse of the amplifi er protects
only the amplifi er, not the vehicle battery.
Use loudspeakers with 2-4 Ω impedance (see table or
installation drawing). Observe the maximum power
handling capacity (music output). Do not connect loud-
speakers to earth, use only the referenced terminals.
6
VA_275_0108.indd 6 VA_275_0108.indd 6
2 (5 A.W.G.).
Amplifi er VA 275
The amplifi er is suitable for connecting a car sound
system with cinch connections.
For the connection to car sound systems with
ISO connection, use Blaupunkt ISO cinch adapters
(7 607 893 093 or 7 607 855 094).
Application options and loudspeaker connection:
Stereo mode
Max. power 2 x 160 watts / 4 Ω
Mono mode
Max. power 1 x 425 watts / 4 Ω
Stereo mode
Max. power 2 x 210 watts / 2 Ω
Stereo mode
RMS power
2 x 75 watts / 4 Ω
Mono mode
RMS power 1 x 210 watts / 4 Ω
Stereo mode
RMS power 2 x 105 watts / 2 Ω
RMS power in accordance with CEA-2006
(< 1% dist. / +14.4V)
Frequency response 10 Hz - 35.000 Hz
Signal-to-noise ratio > 95 dB/A @ RMS
power
Signal-to-noise ratio 80 dB/A @ 1 W /
1 kHz
Distortion factor
(RMS) < 0.03 %
Stability 2 Ω (4 Ω in bridged
mode)
Input sensitivity 0.3 - 8 V
Input sensitivity 0.3 V
Direct Aux IN
Low pass fi lter 50 - 250 Hz
(Low Pass)
High pass fi lter 50 - 250 Hz
(High Pass)
Bass boost 0 to +12 dB
Inputs 2x RCA
2x HighLevel speakers
1x Direct Aux Inputs
3.5 mm (0,35")
stereo
Outputs 2x Loudspeakers
Dimensions
W x H x D (mm) 240 x 54 x 258
W x H x D (") 9,5 x 2,2 x 10,2
Fig. 4
Fig. 5
Fig. 4
Fig. 4
Fig. 5
Fig. 4
25.01.2008 11:00:19 Uhr 25.01.2008 11:00:19 Uhr