Leonard LK1243 Benutzerhandbuch Seite 22

22 Leonard
Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
Water flows inside the refrig-
erator.
The temperature in the appli-
ance is too low/too high.
Possible cause
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
Solution
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.