Start-Up And Use; Starting The Appliance; Setting The Temperature; Chiller System - Indesit baan 13 Gebrauchsanweisungen

Start-up and use

Starting the appliance

! Before starting the appliance, follow the
installation instructions ( see Installation ).
! Before connecting the appliance, clean the
compartments and accessories well with lukewarm
water and bicarbonate.
1. Insert the plug into the socket and ensure that the
internal light illuminates.
2. Turn the TEMPERATURE ADJUSTMENT knob to an
average value. After a few hours you will be able to
put food in the refrigerator.

Setting the temperature

The temperature inside the refrigerator compartment
automatically adjusts itself according to the position of
the thermostat knob.
= warmest
= coldest
We recommend, however, a medium position.
The cooling section of the refrigerator is located inside
the back wall of the refrigerator compartment for
increased space and improved aesthetics. During
operation, the back wall will be covered in frost or
water droplets depending on whether the compressor
is operating or paused. Do not worry, the refrigerator is
functioning normally.

Chiller system

The appliance comes with one of the chiller systems
described below: take note of your system in order to
determine the most efficient food storage method.
PURE WIND / PURE WIND PLUS*
It is recognizable due to the presence of the
mechanism on the top part of the refrigerator
compartment ( see diagram ).
B
A
PURE WIND / Pure Wind Plus maximises air
circulation, improving the efficiency of the evaporator
and helping to achieve the optimal temperature inside
the refrigerator as quickly as possible each time it has
B
B
A
been opened. The blown air (A) is cooled when it
comes into contact with the cold wall, whereas the
hotter air (B) is sucked up ( see diagram ).
The Pure Wind Plus products are also equipped with a
filter which, thanks to the inclusion of silver ions,
makes it possible to reduce bacteria by 70% and to
eliminate odours inside the refrigerator unit, thereby
guaranteeing improved food storage.
If the TEMPERATURE ADJUSTMENT knob has been
set on high values with large quantities of food and
with a high ambient temperature, the appliance can
operate continuously, resulting in excessive frost
formation and excessive energy consumption:
compensate for this by shifting the knob towards lower
values (defrosting will occur automatically).
Static
Models without the Aircooler have the cooling section
in the internal back wall of the compartments. The wall
will be covered in frost or water droplets depending on
whether the compressor is operating or paused: both
cases are normal. If the TEMPERATURE
ADJUSTMENT knob has been set on high values with
large quantities of food and with a high ambient
temperature, the appliance can operate continuously,
resulting in excessive frost formation and excessive
energy consumption: compensate for this by shifting
the knob towards lower values (defrosting will occur
automatically).
In static appliances, the air circulates in a natural way:
the colder air tends to move downwards as it is
heavier. The food should be stored as follows:
Arrangement inside the
Food
refrigerator
Above the fruit and vegetable
Fresh fish and meat
bins
Above the fruit and vegetable
Fresh cheese
bins
Cooked food On any shelf
Salami, bread loaf,
On any shelf
chocolate
Fruit and vegetables In the fruit and vegetable bins
Eggs On the shelf provided
Butter and margarine On the shelf provided
Bottles, drinks, milk On the shelf provided
GB
15