General Information; Power Supply - Philips mz 33 Benutzerhandbuch

XP MZ-33 /22 01ENG 09-05-2000 09:32

GENERAL INFORMATION

CAUTION
Use of controls or adjustments or performance of pro-
cedures other than herein may result in hazardous
radiation exposure
Supplied accessories
- 2 speaker boxes
- remote control with batteries
- AM (MW) frame aerial
- FM aerial
General maintenance
• Do not expose the set, batteries, CDs or cassettes to
humidity, rain, sand or excessive heat caused by heating
equipment or direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing
alcohol, ammonia, benzene or abrasives as these may
harm the housing.
Pagina 5
MZ-33 / 22 page 5

POWER SUPPLY

2 1
Batteries for the remote control
• Open the battery compartment and insert two batteries,
type AA, R06 or UM3 (preferably alkaline) with the
correct polarity as indicated by the + and – symbols
inside the compartment.
Important! Remove the batteries if they are exhausted or if
the unit is not to be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Speaker connections
The speaker terminals are click-fit connectors. Use them as
shown below.
– Connect the unmarked wire to the red terminal and the
marked black wire to the black terminal.
• When headphones are inserted into the headphone
socket the speakers are disconnected.
R L
AUX in
6 Ω
speakers
LEFT LEFT
– +
RIGHT RIGHT
– +
Power supply
1 Check if the mains voltage, as shown on the type plate
located on the bottom of the set, corresponds to your
local mains voltage. If it does not, consult your dealer or
service centre.
2 If your set is equipped with a voltage selector on the
bottom of the set, adjust the selector so that it matches
with the local mains.
3 Connect the mains plug to the wall socket and the set is
now ready for use.
™ The clock display ... : ... flashes.
4 To disconnect the set from the mains completely,
remove the plug from the wall socket.
For users in the UK, please follow the instructions on page 2.
POWER-SAVING AUTOMATIC STANDBY
As a power-saving feature, the unit automatically switches
to standby if:
• 15 minutes after a CD has reached the end and no
control is operated.
• after more than 24 hours no controls are operated
Safety information
• Place the set on a hard and flat surface so that the
system does not tilt. Make sure there is adequate
ventilation to prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
This set complies with the radio interference
requirements of the EU.
5