Technical Specifications - VINCENT CD-S1.1 Bedienungsanleitung

Symptom
Poor sound quality
The remote control
cannot perform
any functions
Humming low
frequency noise is
audible, even as
no audio source is
playing back
No sound in the
headphones
D/A converter:
Frequency response:
Total Harmonic Distortion:
Signal to Noise Ratio:
Dynamic Range:
Audio Output Voltage:
Channel Separation:
Outputs:
AC power connection type:
Dimensions (WxHxD):
Weight:
Colour:
Tubes:
Vincent
42
SEARCH FOR ERRORS
Possible Cause
Analogue audio outputs of the CD player
are connected to phono inputs of the
amplifier/receiver/preamplifier.
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the chapter "Tips".
Headphones not plugged in.
The volume control "LEVEL" (9) has been set
too low.
CD playback has not yet been started.
Headphones faulty.

TECHNICAL SPECIFICATIONS

Countermeasure
Use a normal line level input ("CD" or "LINE
IN") on these devices.
Check the cables and cable connections.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
Connect the 6.3 mm jack plug of the headpho-
nes to the connection socket "PHONES" (8).
Cautiously raise the volume with this dial.
Start playback with "PLAY/PAUSE" (5)(24).
Use another set of headphones.
24 bit / 96 kHz
10 Hz - 20 kHz (±0.5dB)
< 0.003 %
> 95 dB
> 100 dB
2 V ± 1.6 dB
> 90 dB
1x stereo XLR, 2x stereo RCA, 1x digital coaxial
230V / 50 Hz
430 x 106 x 328 mm
8.5 kg
silver / black
1 x 6N16