Fault Finding - Siemens se 60a591 Gebrauchsanweisung

en

Fault finding

Resolving minor problems
yourself
Experience has shown that you can
resolve most problems that arise during
normal daily usage yourself, without
having to call out a service engineer. Not
only does this save costs, but it also
means that the appliance is available for
use again that much sooner. The following
list of common occurrences and their
remedies should help you identify the
causes of most problems.
Problems ...
... when the appliance is
switched on
Incorrect language set.
Return to language selection
1. Switch off the appliance.
2. Switch on the appliance, holding
down the main switch until the
display is lit.
3. Select the language and
acknowledge with "ok".
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been
inserted.
The appliance door has not been
shut properly.
The appliance door was closed
without starting the programme
first.
52
Some time after the programme
has started, a continuous buzzer
is emitted.
The appliance is not being filled with
water. When the appliance door is
opened, "Check water supply!" is
indicated.
Tap not turned on.
Turn on the tap fully and press
the "Continue" button
on the appliance. Then close the
appliance door to continue the
programme.
The filter on the water supply hose
is blocked.
Switch off the appliance and pull
out the mains plug. Turn off the
tap. Then clean the filter which is
situated at the connection of the
Aqua Stop or supply hose. Finally,
restore the power, turn on the tap,
switch on the appliance and close
the door to continue the
programme.
Warning
Remember:
The appliance may be repaired
by a technician only. Improper
repairs may cause
considerable damage and/or
injure the user.
52