Siemens se 60a591 Gebrauchsanweisung Seite 47

Timer programming
You can delay the start of the programme
by up to 24 hours in ½ hour steps.
If the Timer programming option is
selected, "Delay start 0:00 hrs" is
displayed.
Select the desired time.
Return to the main menu and start the
selected programme.
Close the door. The time begins to
count down.
To interrupt or check the countdown,
open the door.
When the set time has elapsed, the
programme starts automatically.
Until the programme starts you can
change the set time and selected
programme. Return to the main menu
by pressing the "Back" button and
change the settings. Finally, restart
the programme.
To delete Timer programming, reset
the time to 0:00.
Reduce time
You can reduce the running time of
automatic programmes. An optimum
cleaning result is still obtained as both
the water and energy consumption is
increased.
If the Reduce time option is selected,
"Reduce time: Off" (factory setting) is
displayed.
Select "Reduce time: On".
Return to the main menu and start the
selected programme.
If you do not want to use Reduce time
the next time you use the dishwasher,
you must switch off the option again.
Degree of drying
If the "Degree of drying" option is
selected, "Normal drying" is displayed
(factory setting).
Alternatively, you can select "No drying"
or "Extra drying".
The temperature of the final rinse is
increased in all programmes for "Extra
drying". (Note the higher temperature
may not be suitable for fragile utensils.)
Buzzer volume
You can vary the volume of the buzzer or
switch it off completely.
If the Buzzer volume option is selected,
"Buzzer 4" is displayed (factory setting).
You can select value 0 (buzzer
switched off) or values from 1 (quiet)
to 6 (loud). Buzzer is emitted briefly,
indicating the volume which
corresponds to the value just selected.
Water hardness
Before using the appliance for the first
time or if the water hardness changes,
the dishwasher softening system must be
adjusted to the degree of hardness of your
tap water. Proceed as described in the
chapter "Adjusting the softening system".
Rinse aid dosage
You can adjust the rinse aid dosage.
If the Rinse aid dosage option is
selected, "Rinse aid 4" is displayed
(factory setting).
Do not change this setting unless there
are streaks (reduced value) or water
stains (increased value) on the utensils.
You can select a value between 0
and 6.
en
47