Something Not Working - Küppersbusch GSV 6600 Bedienungsanleitung

Something not working

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions
given here, without calling out an engineer.
...a fault code appears
The dishwasher will not start or stops during operation and a sequence of intermittent audible signals are heard.
Open the dishwasher's door.
The intervention of an alarm is indicated by:
- continuous flashing of the indicator light of the running programme,
- a combination of flashes and pauses of the end of programme indicator light and by intermittent audible signals (as described in
the chart).
Carry out the following suggested corrective actions.
Fault code / malfunction
- continuous flashing of the indicator light
of the running programme
- 1 intermittent audible signal
- 1 flash of the "end of programme"
indicator light
The machine does not fill with water.
- continuous flashing of the indicator light
of the running programme
- 2 intermittent audible signals
- 2 flashes of the "end of programme"
indicator light
The dishwasher will not drain.
- continuous flashing of the indicator light
of the running programme
- 3 intermittent audible signals
- 3 flashes of the "end of programme"
indicator light
Once the checks have been carried out, press the programme selection/cancel button and close the dishwasher's door. The
programme will continue from the point at which it was interrupted. If the fault code reappears contact your local Service Force
Centre.
For other combinations of fault codes not described in the above chart, please contact your local Service Force Centre.
...there are problems when operating the dishwasher
Malfunction
The programme does not start
There is a whistling noise during
washing
Possible cause
The water tap is blocked or furred with
limescale.
The water tap is turned off.
The filter (where present) in the threaded
hose fitting at the water inlet valve is blocked.
The water inlet hose has not been correctly
laid or it is bent or squashed.
The sink spigot is blocked.
The water drain hose has not been correctly
laid or it is bent or squashed.
Anti-flood device is activated.
Possible cause
The dishwasher door has not been properly
closed.
The main plug is not plugged in.
The fuse has blown in the household fuse box.
The whistling is not a cause for concern.
33
Solution
Clean the water tap.
Turn the water tap on.
Clean the filter in the threaded
hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain hose
connection.
Close the water tap and contact
your Service Force Centre.
Solution
Close the door.
Insert the mains plug.
Replace the fuse.
Use a different brand of detergent.