Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLE SHOOTING
1. If the power supply indicator is off and the laser doesn't work, please check the power supply and the
input voltage.
2. In Stand-Alone operation, if the power supply indicator is ON and sound active indicator is OFF, but the
laser doesn't work.
A. Because sound is too small and cannot activate laser running, please increase the music volume or
increase audio sensitivity on rear panel.
B. Please check if unit has been set up in slave mode, or DMX mode.
3. In Master-Slave operation, slave units don't function, please check as below.
A. Make sure there's only one master in the chain, and the others are set in slave mode.
B. Make sure to control the units without DMX controller.
C. Make sure to use a good quality power cable and XLR connector.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator is unlighted, please check as
below
A. Make sure DIP switch #1 is ON.
B. Make sure to have a good XLR connection.
5. In DMX operation, the unit can't be controlled by the DMX console, but the DMX signal indicator is
flashing, please make sure the DMX console and unit have the same channel.
6. If the output beam direction above is unusual, please restart the unit.
7. If the unit is fail, please turn off the unit, and then turn on again after 5 minutes.
After trying the above solution you still cannot sort out the problem, please contact your dealer or our
company for service.
www.musicstore.com
8
Werbung
