Error Messages - Sharp MD-MT90H Bedienungsanleitung

Error Messages

ERROR
MESSAGES
BATT EMPTY z The battery is run down.
BLANK MD z Nothing is recorded.
Can't COPY z You tried to record from a copy prohibited MiniDisc. z Record using the analogue cable.
z A track cannot be edited.
Can't EDIT
Can't READ (*) z The disc data cannot be read because the disc or
unit is damaged.
z Recording cannot be performed correctly due to vi-
Can't REC
bration or shock.
Can't STAMP z Stamp function does not work.
Can't WRITE z Cannot save the TOC information correctly to a Mini-
Disc. (A large portion of the disc has been dam-
aged.)
z The disc is scratched.
DEFECT
DISC FULL z The disc is out of recording space.
z The microprocessor has reported a system fault and
Er-MD (**)
the unit is out of order.
z The unit is in the hold mode.
HOLD
z You removed a MiniDisc whilst recording or editing. z Turn off the power and remove the MiniDisc.
LOCKED
z A disc has not been loaded.
NO DISC
E-39
ENGLISH
MEANING REMEDY
z Charge the rechargeable battery or replace the alkaline
battery (or use the AC adaptor for power).
z Replace the disc with a recorded disc.
z Change the stop position of the track and then edit it.
z Reload the disc.
z Replace it with another recorded disc.
z Re-record or replace it with another recordable disc.
z Check the number of tracks.
z Replace the disc with another recordable disc.
z If the sound you hear is not right, record again.
z Replace the disc with another recordable disc.
z Replace it with another recordable disc.
z To have it repaired, go to the distributor where you pur-
chased the unit.
z Cancel the hold mode.
z Load a disc.