Operation - patura p1500 Bedienungsanleitung

Note: If required, this energiser can be used as part of a solar installation, by connecting it
to a battery and solar panel(s). For further information about solar installations, please refer
to our "Electric Fencing Catalogue".

Operation

Switch
Select the power and speed settings using the switch.
Setting
OFF
OFF
Off
OFF
Battery test
Day save mode
(fast at night +
slow during the day)
Night save mode
(slow at night +
fast during the day)
Half power
(fast)
Full power
(fast)
Reading voltage
The Indicator lights show the voltage at the output terminals of the energiser. When first
connected to the power source, all the Indicator lights illuminate for a period of 2 seconds. There
after, the indicator lights display the output voltage at each pulse. This indicates that the energiser
is operating normally. After two seconds, the energiser starts pulsing. Each Indicator light seg-
ment represents an increment of approximately 1 kV (1,000 V) of output voltage. For example, if
the first four Indicator light segments are illuminated at each pulse, the output voltage is approxi-
mately 4 kV (4,000 V).
Description
The energiser is off and is not operating.
The energiser continues to operate at full
power on Slow speed, but the Indicator lights
show the battery level for a period of 30 seconds.
See "Battery test setting" on page 35 for
an explanation of the Indicator lights.
The energiser is operating at full power on Slow
speed (pulses every 2.5 seconds) during the day
and Fast speed at night (pulses every 1.5 seconds)
The energiser is operating at full power on Fast
speed during the day (pulses every 1.5 seconds)
and Slow speed at night (pulses every 2.5 seconds)
The energiser is operating at half power
and fast speed (approximately 1.5 seconds
between pulses).
The energiser is operating at full power
and fast speed (approximately 1.5 seconds
between pulses)).
- 34 -