Installing And Operating Your Freezer - Nabo GS 1820 Bedienungsanleitung

BEFORE USING THE APPLIANCE
• Do not place glass bottles or beverage cans in the ice-making
compartment as they can burst as the contents freeze.
• Do not place explosive or flammable material in your freezer.
Place drinks with high alcohol content vertically in the freezer
and make sure that their tops are tightly closed.
• When removing ice from the ice-making compartment, do not
touch it. Ice may cause frost burns and/or cuts.
• Do not touch frozen goods with wet hands. Do not eat ice-cream
or ice cubes immediately after you have taken them out of the
ice-making compartment.
• Do not re-freeze frozen goods after they have melted. This may
cause health issues such as food poisoning.
• Do not cover the body or top of freezer with lace. This affects the
performance of your freezer.
• Secure any accessories in the freezer during transportation to
prevent damage to the accessories.

Installing and operating your freezer

Before starting to use your freezer, you should pay attention to the
following points:
• The operating voltage for your freezer is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due
to ungrounded usage.
• Place your freezer where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas
ovens and heater cores, and at least 5 cm away from electrical
ovens.
• Your freezer should never be used outdoors or exposed to rain.
• When your freezer is placed next to a deep freezer, there should
be at least 2 cm between them to prevent humidity forming on
the outer surface.
• Do not place anything on your freezer, and install your freezer in
a suitable place so that at least 15 cm of free space is available
above it.
• Do not place heavy items on the appliance.
• Use the adjustable front legs to make sure your appliance is
level and stable. You can adjust the legs by turning them in either
direction. This should be done before placing food in the freezer.
• Before using your freezer, wipe all parts with a solution of warm
water and a teaspoon of sodium bicarbonate, then rinse with
clean water and dry. Place all parts in the freezer after cleaning.
EN
27