Master/Slave Operation; Operation; Control Board - Eurolite Akku Mini Party Rgbw Spot Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired Master-mode for the master-device, as described in the chapter Control Board.
Set the DMX address d001 for all slave-devices.

OPERATION

After you connected the device to the mains, it starts running. The LED display lights up and you can now
choose the desired settings via the buttons MENU, UP, DOWN and ENTER. The device has two operating
modes. It can be operated in stand-alone mode via the control board or in DMX-controlled mode via any
standard DMX controller.

Control board

The display shuts off after 10 seconds of inactivity. With the touch of a button it lights up again.
Menu Up / Down
d001. d001.-d512.
Programs
A1.XX
A1.01 - A1.18
The control board offers several features, i.e. setting the DMX starting address
or running an internal program.
Browse through the menu by pressing MENU. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every
mode by pressing MENU. The functions provided are listed in the following
sections.
Enter
DMX address setting
A1.01: R+G+B+W
A1.02: R
A1.03: G
A1.04: B
A1.05: R+G
A1.06: G+B
A1.07: R+B
A1.08: W
A1.09: R, G
A1.10: R, B
A1.11: R, W
A1.12: G, B
A1.13: G, W
A1.14: B, W
A1.15: R, G, W
A1.16: R, B, W
A1.17: G, B, W
A1.18: R, G, B
19/24
Description
Solid colors (Master-Mode)
00110060.DOC, Version 1.0