Setting The Alarm - Silvercrest SRW 250 A2 Bedienungsanleitung Und Serviceinformationen

SRW 250 A2 Alarm Clock Radio

Setting the Alarm

Make sure that the clock has been set correctly (see the page 14 – Setting
the Time). You can set two different alarm times (ALARM1 and ALARM2).
The alarm time can only be set while the device is powered off. If it is
powered on, press the ON/OFF-FM/AUX button [2] to power the device
off.

Press and hold the ALARM1 [3] or ALARM2 [5] button until the hour
display flashes [10].

Press the – [7] or + [8] button to set the hour. You can also press and
hold the – [7] or + [8] button.

Press the ALARM1 [3] or the ALARM2 [5] button quickly again to set
the minutes. The minutes flash on the display [10].

Press the – [7] or + [8] button to set the minutes. You can also press
and hold the – [7] or + [8] button to set the minutes in 10-minute
steps.

Press the ALARM1 [3] or the ALARM2 [5] button quickly again to set
the alarm volume to the desired level from 00 to 16. The current
volume level flashes on the display [10].

Press the – [7] or + [8] button to set the alarm volume. You can also
press and hold the – [7] or + [8] button. You can set different alarm
volumes for the two alarm times (ALARM1 and ALARM2).

Wait until the display [10] stops flashing or quickly press the
ALARM1 [3] or the ALARM2 [5] button.
18 - English