Led & Controls; Led; The Rear (Control) Panel; The Control Panel - Adam S1X Bedienungsanleitung

4.1

LED

On the bottom of the tweeter you find
an LED. It indicates Power on and, in
case of an overload, the function of the
protective circuit.
Please note: When the speaker is
switched on, the LED will flash red a
few times. This does not indicate an
overload!
• The LED starts to glow green during
normal operation (the power switch
is located on the rear side of the
speaker).
• In case of an overload, the OL LED will
flash red. The protective curcuit will
safe your speaker from damage.
4.2

The control panel

On the rear you will find a control
panel that allows detailed fine-tuning
of your loudspeakers to your particular
room acoustics and personal listening
preferences. The following tips are
intended to assist you at using the
controls in the best manner.
Please note that using the controls may have a great impact on the overall
sound characteristics of your loudspeakers. We recommend using the
controls with utmost care and only after several audio tests with familiar
recordings.
4.
LEDs / Controls
Figure 5: Control panel
LED
Figure 4: LED
9