Weidmuller DPA Bedienungsanleitung Seite 15

 DPA/POT
en
Potentiometer/Slidewire
Position measurement
•Operation
General
The DPA/POT allows you to set two independent trip points on a
slidewire/potentiometer wiper position measurement. The alarm
outputs are dual SPDT relay contacts.
Setup
The alarm relay coils operate according to each setpoint/deadband
configured via front panel multiturn potentiometers. Internal push
fit jumpers determine the alarm type (high or low acting) and coil
energisation (normally energised/de-energised).
x
DPA/POT block diagram.
Power
Supply
Alarm 1
Alarm 2
1